So I got the full receptacle and cable replacement kit and intended on doing a blog entry about how everything on a boat takes longer to install than you think it should. I knew our canine crew would be a big part of the installation since it was taking place in the cockpit, their standard afternoon nap place.
Here's how it went.
Step 1 - Turn off the boat power and unplug the cable. Safety first.
Step 2 - Find the package that got delivered and get a few tools together.
Step 3 - Take the parts out and look over the instructions. And let me say, the instructions are fantastic and give absolutely everything you need with clarity.
Step 4 - Remove the 4 screws holding in the power receptacle.
Step 5 - Dylan needs to inspect. It's important to point out that now would have been the wrong time to realize that you should have unplugged the power cable from the pedestal on the dock.
Step 6 - Push Dylan out of the way since he decided he had to be right in front of all the action.
Step 7 - Unscrew the wire screws and the plug falls out. I also cleaned up the old gasket and removed some sealant original to the boat that should have never been installed with the gasket. And I sanded the copper ends a little to remove any corrosion - there was some.
Step 8 - Put the gasket over the plug, push the wires into the color coded receptacles, and tighten with the included Allen wrench. It's a really beefy connection that is much more rugged than the original.
Step 9 - Make sure to not bother Dyna's afternoon nap. She's deaf so she still didn't realize I had been there for 10 minutes already.
Step 10 - Push the wires back and use the original 4 screws in the exact same holes to finish the receptacle installation. It's so nice that everything lines up perfectly.
Step 11 - Feel how it works and make sure there's no wiggle. It all feels perfect and strong.
Step 12 - Saw off the end of the cable to replace the plug with one that matches the new SmartPlug. I made sure to leave a couple of inches on the end so I could splice it if I needed to use the plug again. Most likely, it's already been misplaced and is lost.
Step 13 - My trusty wife is called to help with the last stage of cutting so as not to drop the end and wake up Dyna.
Step 14 - No luck. Dyna sensed all the commotion and now decided that she needed to lay on top of the cable being worked on and the instructions.
Step 15 - The instructions tell you exactly how much inner insulation to remove. There's also this white cotton-like material that gets cut away between the wires.
Step 16 - Prepare the plug case and put the included cone over the wires to assist in pushing the wires into the cover.
Step 17 - The instructions say to use liquid soap because it's a tight waterproof fit. This took about 5 minutes to push on because it was stiff but easy enough.
Step 18 - With all the insulation cut to instruction specifications, it all just fits together perfectly. There's a very strong strain relief part of the assembly that actually holds the cable. The wires then slip in and are tightened with the Allen wrench.
Step 19 - Slide the cover back onto the plug and screw in 4 included screws to lock it all in place.
Step 20 - Convince Karen that she can insert the cable now on her own. The plug only goes on one way and gives a positive lock with the 2 side silver latches. The receptacle cover has two more locking points and folding it over grabs and locks the plug even more securely.
Step 21 - Admire the results.
Extra expenses for installation: $0
A planned 2 hour boat project that took only 1 hour: Priceless























































